![]() If you are using IPv6 in your environment, then you have to scroll a little lower. You’ll have to arrow down quite a bit until you get to IPv4 settings. Just about all of the Dell PowerEdge servers have a dedicated port for iDRAC, so may as well use it. To set a static IP for iDRAC, arrow down to LAN Parameters and press Enter.Īt the very top, you should see NIC Selection, which I recommend setting to Dedicated. Some of the newer servers now run iDRAC 9. This is an older server, so it’s still on iDRAC 6. You’ll definitely want to make sure iDRACx LAN is set to ON. ![]() It should say Press CTRL + E for Remote Access Setup within 5 sec. When you enter the iDRAC setup, there are quite a few options. You’ll need to quickly press CTRL + E as you only have about 5 seconds before the boot process continues. To get started, boot up your server and wait until you see the iDRAC configuration section pop up during the boot process. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |